Specifications

Printer Driver Controls
Section 3-22
WOOD
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 100 15 500 1 .020”
25 100 33 500 1 .020”
30 100 40 500 1 .020”
35 100 47 500 1 .020”
40 100 53 500 1 .020”
45 100 60 500 1 .020”
50 100 67 500 1 .020”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 100 2.5 500 1 .030”
25 80 4.2 500 1 .030”
30 80 5.0 500 1 .030”
35 80 5.8 500 1 .030”
40 80 6.7 500 1 .030”
45 80 7.5 500 1 .030”
50 80 8.3 500 1 .030”
VECTOR CUTTING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 60 0.8 250 1 .125”
25 50 1.3 250 1 .125”
30 50 1.6 250 1 .125”
35 50 1.9 250 1 .125”
40 50 2.1 250 1 .125”
45 50 2.4 250 1 .125”
50 50 2.7 250 1 .125”
COMMENTS
When engraving wood with a laser, a brown, maple syrup like residue will deposit on the surface of the
wood. This is normal and impossible to eliminate by POWER, SPEED, or PPI changes. More residue
will be present when engraving deeper and/or slower. This residue washes off with water and a sponge.
We recommend using a kitchen sponge with a nylon string mesh wrapped around it. Dampen the sponge
and wipe off the residue. A damp chamois cloth works well also. Do not use paper towels or a regular
sponge because these materials will get lodged in the engraved area when wiping and are extremely
difficult to remove. A method to avoid cleanup is to mask the wood with transfer tape and peel off the
tape after engraving. If desired, after engraving and before peeling off the tape, spray paint can be
applied to color fill the engraved areas. After the paint dries, peel off the tape. If an intricate drawing has
been engraved and there are many small pieces of tape to remove, it may be easier to flood the masking,
after engraving, with water. This will loosen the tape and it can be easily removed by rubbing it off by
hand. In the vector cutting example, the wood was elevated from the table to let smoke and heat escape
from underneath. If elevating the wood, mask and/or dampen the bottom side of the wood very lightly
and the water acts as a heat sink to prevent the underside from flaming and charring. Elevating the wood
also helps to determine whether the laser has passed completely through since the cut pieces will fall
through to the table when cutting is finished. If raising the wood, set up the drawing so that the inner
pieces of the drawing are cut first, otherwise pieces may fall through at the wrong time.