User guide

Page 4
other device with a high speed microprocessor (these generate
broad band Radio Frequency Interference -RFI). Of course, you
should keep in mind that the emitter cables are 10’ long.
13. Observe the Status LED of the MRZ-260.
14. Once you have found a location, test to
see if the range is adequate and that
macro reliability is perfect. Start with
the antenna angle set to 45 degrees and
positioned so that the long side of the
antenna is facing the customer’s favorite
seating position.
15. Now that the location is fixed, connect each of the emitters to
the appropriate IR output and run the cable to the appropriate
component. Do not attach the emitters to the front panel yet!
Utilize the included preprinted labels to identify which emitter
goes to which component. If you’d like to make your own, the
slots for the labels have been sized at 12mm to enable a
Brother P-Touch 12mm label to fit perfectly.
NOTE: TiVo, Replay TV, other DVRs, Satellite Receivers and Cable
Boxes are all extremely sensitive to IR overload or saturation. For
this reason, it is recommended that you always connect the IR
flashers for these types of component to the Variable IR Outputs of
the MRZ-260.
MRZ-260 BASE STATION
The red POWER LED indi-
cates that the MRZ-260 is
powered on.
The red STATUS LED flash-
es when a command is
pressed from the remote.
45°