Owner manual

ManualsBrandsUniversal Remote Control (URS) ManualsEquipmentMSC-400

Notice to User

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or tele-

vision reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one more of

the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

Warning

Changes or modifications not expressly approved by the manufacturer could void

the user's authority to operate the equipment.

Note : The manufacturer is not responsible for any Radio or TV interference

caused by unauthorized modifications to this equipment. Such modifications

could void the user's authority to operate the equipment.

MSC-400 System Quick Reference Guide

Front Views - Flip for Rear Views

Start with the antenna angle set to 45

degrees and positioned so that the

long side of the antenna is facing the

customer’s favorite seating position.

Power LED indicates

that the MSC-400 is

powered on.

USB 1 LED indicates that

the USB Programming Port

(Front Panel USB) is

connected to a PC.

Learning Sensor for learn-

ing IR commands.

Normally, learning is more

convenient via a remote.

Front Panel USB port is

used ONLY for

PROGRAMMING

USB 2 LED indicates that

the USB PC Keyboard Port

(Rear Panel USB) is

connected to a PC.

Sensor LEDs light when a

Sensor is sensing that a

component is ON (Video is

present or Voltage is high).

MSC-400

Master System Controller

Front Panel

RFX-250

Narrow Band RF Receiver

Front Panel

NOTE: MSC Editor Software is not

included with the MSC-400. It can

only be downloaded from the URC

Dealer Only website. If you have

not registered yet, call your distrib-

utor or sales representative for a

registration code and use the

Dealer Login at:

www

.universalremote.com

Status LED lights

whenever an RF sig-

nal is received and

UNDERSTOOD.

Once the RFX-250 is correctly con-

nected, the POWER LED lights.

If the RF LED lights, the RFX-

250 must be moved to a new

mounting location. It is receiv-

ing in-band RF INTERFERENCE.

45°

Summary of content (2 pages)

PAGE 1
MSC-400 System Quick Reference Guide Power LED indicates that the MSC-400 is powered on. Status LED lights whenever an RF signal is received and UNDERSTOOD. USB 1 LED indicates that the USB Programming Port (Front Panel USB) is connected to a PC. USB 2 LED indicates that the USB PC Keyboard Port (Rear Panel USB) is connected to a PC. Notice to User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
MSC-400 System Quick Reference Guide MSC-400 Master System Controller Rear Panel IR and RS232 Outputs For RS-232: Connect to Outputs 7-12 only. Order either RS232M (Male connector for component) or RS232F (Female connector for component). No RS232 cables are included with the MSC-400. For IR: Outputs 1-6 are IR only. Outputs 7-12 can be used for either RS232 or IR. Standard emitters can be used on 1-6, sleeved emitters should be used for Outputs 7-12.