Owner manual

Page 4
TRG-100 UMOTION REMOTE
Installing the Batteries
Open the battery cover by pushing up on the
spring lock at the bottom of the cover. Remove
the cover.
Observe the + and – polarity indicators inside
the battery compartment and the batteries.
Place the two AA batteries into their positions
in the battery compartment.
Now, replace the battery cover and snap it into
place.
Main: Displays the MRX-20’s System menu via a connected display
device.
l
When a room is OFF: Pressing Main sends out a series of
commands to turn ON all required devices to view the
on-screen display.
l
When a room is ON: Pressing Main, while the display
device is on, opens the System Main menu of the MRX-20.
Umotion: Allows for motion control and button selection via on-screen
interface. Press the Umotion button to activate on-screen movement.
Point the TRG-100 towards the television. As you move the remote, an
on-screen pointer will mimic your movements. To select a button,
hover over your selection and press the Umotion button. Placing the
remote down for ten seconds, exits the on-screen motion control.
l
When a room is OFF: No action occurs.
l
When a room is ON: The display device shows a
Shortcuts Menu screen.