User's Manual

Connect the security floodlight
only to 110-120 volt, 60 Hertz
electrical power. There is
sufficient voltage and current to
harm you if you come into contact
with the 110-120 volt, 60 Hertz
electrical power.
1. Turn off all electrical power to the old
floodlight as follows:
WARNING
Ensure that the 110-120 volt, 60
Hertz electrical power to the old
floodlight is OFF. There is
sufficient voltage and current to
harm you if you come into contact
with the 110-120 volt, 60 Hertz
electrical power.
A. Turn the old floodlight ON.
Observe the floodlight and make
sure the floodlight is lit.
B. At your circuit breaker or fuse
box, set circuit breakers to OFF
or remove fuses until you
observe that the old floodlight is
no longer lit.
C. The safest procedure is to set
the MAIN circuit breaker or
power switch to OFF. When the
old floodlight is off, proceed to
step 2.
2. Remove flood lamps from old
floodlight.
3. While holding the old floodlight,
remove two screws holding the old
floodlight to an electrical box. Save the
screws for now.
4. While holding the old floodlight,
observe the wires: white, black or
green (if supplied).
5. Remove wire connectors from the old
wiring. Remove the floodlight.
6. Observe the electrical box. All
standard electrical boxes can be used
for installation of the new security
floodlight.
Installation of the Security
Floodlight
Install the new security floodlight as follows:
WARNING
Ensure that the 110-120 volt, 60
Hertz electrical power is OFF.
There is sufficient voltage and
current to harm you if you come
into contact with 110-120 volt, 60
Hertz electrical power.
1. While holding the security floodlight near
the electrical box, twist (clockwise) the
white wire from the electrical cable and the
white wire from the security floodlight
together. Then screw (clockwise) a wire
connector onto the wires. Pull the wire
connector to ensure tightness.
2. Twist (clockwise) the black wire from the
electrical cable and the black wire from the
security floodlight together. Then screw
(clockwise) a wire connector onto the wires.
Pull on the wire connected to ensure
tightness.
3. If green wire is supplied, attach the bare
wire from the electrical cable and the green
wire from the security floodlight together
with a wire connector. Pull on the wire
connector to ensure tightness.
BARE WIRE
WHITE
BLACK