Installation manual

Page 9
MRX-1 BASE STATION
Composite Video Input (A/V Receiver DVD, VCR input, etc) using
a shielded RCA to RCA video cable with gold ends.
5. To Test Video Sensing, once the system has been powered up,
turn the sensed device on. The Sensor LED on the MRX-1 front
panel, should illuminate in Blue. Turn the Sensed device off. The
LED should turn off. If not, check connections and confirm the
device is not outputting a ‘black screen’ or some other video
sync information when off.
6. Confirm Video Signal to the A/V Receiver by selecting the Input
to which the Sensed device is connected. (Be sure TV or video
display is on, connected and switched to the appropriate input.)
Programming
To program a Video or Voltage Sensor into CCP MRX-1:
1. Click on the IF/Else icon within the macro window to add an
IF/Else statement.
2. Double click on the IF(True) line to open the IF Setting window.
3. Click the Sensor button.
4. Select the MRX-1 base station from the Base station drop down
list.
5. Click on the Sensor drop down list to select Sensor 1 and check
whether the Sensor should check if it is on or off.
6. Press Ok to save the configuration.
7. Now the macro will Sense if a device is on.