Installation manual

Page 13
Network Discovery
Adding a MRX-1 in CCP, modifying it’s Settings and test-
ing RS-232 and Relay Commands.
1. Inside the CCP editor, select Program then Configure Home.
2. Add a MRX-1 base station and the properties window opens.
3. Type in a descriptive Name for the MRX-1 unit and select a RFID
if using a RFX-250.
4. Either type in the MAC address which can be found on a sticker
located on the bottom of the unit or click on the Discover but-
ton.
5. The Discover window opens to reveal a list of connected MRX-1
units. Highlight the preferred MRX-1 MAC address and select
Apply. The Discover window closes.
MRX-1 BASE STATION
Status