Installation manual

Page 16
MRX-1 BASE STATION
Overview of IR Routing
There are several considerations to take into account when you are
installing an MRX-1 to control an array of identical components:
1. Each identical component must receive IR commands ONLY
from a dedicated Flasher affixed to its front panel or a rear panel
direct IR input. The SIGNAL of the remote should be set to
Network or RF ONLY for each identical component. IR can still
be utilized for other devices in your system!
2. When connecting a flasher from the MRX-1 to your component
make sure to notate the Flasher Output Number being used.
Network or RF Setup in CCP
1. Open the RF Setup Window in CCP
The RF Setup window opens after selecting RF Control from the
Program Menu. The RF Setup window is composed of a “spread
sheet” of options for EACH of your devices.
2. Adjust the Signal For Each of the Identical Devices
The RF Setup window enables you to adjust the Signal output for
each device individually, by clicking on the intersection of a row
and a column and then selecting Netw
ork or RF (for optional RFX-
250) from the three options shown in the pull down list box.