Specifications

DStv PVR Remote Control Manual Page 21
5.6 Code Verification
Quick Programming Summary
Press and hold SHIFT until the mode window blinks 3 times.
Press the YELLOW button.
Press 1 to 5, counting the blinks for each.
5.6.1 What is this used for?
The feature allows you to determine the code for a device that you programmed using the “Step-
and-Set” method (see page 10). This code can then be used in future.
5.6.2 How to verify a code
The device codes for X, Y or Z modes can be verified as follows :
1. Check that the dial is on the mode for which you wish to verify a code (X, Y or Z)
2. Press and hold the SHIFT button until the mode window blinks 3 times.
3. Press the YELLOW button to indicate that you want to verify a code. (The mode window will
blink 3 times to indicate acceptance).
4. Press 1 and count the times the mode window blinks.
5. Press 2 and count the times the mode window blinks.
6. Press 3 and count the times the mode window blinks.
7. Press 4 and count the times the mode window blinks.
8. Press 5 and count the times the mode window blinks.
Note
X The 5 numbers “blinked” are the code.
X No blink indicates a 0 (zero).
X You can only verify codes in modes X, Y or Z. Attempting to verify a code in the TV1 (red
mode) or TV2 (blue mode) will result in the mode window blinking twice and the remote
returning to normal operation.
X If you press digits other than 1 – 5, or press buttons out of sequence, these will be ignored.
5.7 Reset
To reset macros and favourite channels to factory defaults :
1. Press and hold the SHIFT button until the mode window blinks 3 times.
2. Press the YELLOW button. (The mode window will blink 3 times to indicate successful
completion).
Note
X This will effectively delete macros and favourite channels for both TV1 (red mode) and TV2
(blue mode).