Specifications

Note: SET appears in the LCD for 20 seconds to indicate that

the remote control is ready to be programmed. The following

steps must be entered while SET appears in the LCD.

4 Point the remote control toward the device that was

turned on in Step 1 and press in the first three-digit Set-

Up Code number for that device using the number buttons

(0-9) on the remote control. SET followed by the number

will appear in the LCD.

Your device will turn off when the correct Set-Up Code

number has been selected. If the device does not turn

off, press in the next Set-Up Code number from the listing.

Continue to select Set-Up Code numbers until your

device turns off, before you proceed to Step 5.

Note: If you have tried all of the three digit Set-Up Code

numbers listed for your device and it still did not turn off, please

proceed to the Auto Search Method on page (10) to

program your remote control.

5 Once your device turns off, press the Device Button

selected in Step 3 once again to store the Set-Up Code

number. PASS will flash in the LCD.

6 Test the remote control for your device. Try the POWER,

CHANNEL UP AND DOWN, VOLUME UP AND DOWN

buttons, etc. If any of the buttons do not perform as they

should, please repeat the set-up from Step 1 using the

next Set-Up Code number for your device.

Note: Some audio/video devices have separate buttons for

POWER ON and POWER OFF. To operate these devices on

the remote, press the corresponding DEVICE Button to turn the

equipment ON and press the POWER button to turn the

equipment OFF.

7 Please repeat the above steps to program the remote

control for each of your other devices.

Using Your Remote