User manual

7. Once you complete the programming and wish to exit

the Learning mode, press the MAIN button. Exit from the

SETUP mode by pressing the MAIN button once again.

Tip: Only follow these instructions if you actually want a

code sent when changing devices. Some users do not want

a Device to send out a code when changing to that device.

For example: You program the AMP's TV input code on the

TV device, and are in the DVD device pages because you

are controlling the DVD player. The AMP's input is set to

DVD. Now you want to quickly adjust the picture on the TV.

If you push the TV Device button, it will change the input

on your AMP to TV and you will not be able to adjust the

picture for your DVD. In this case, it would be better not to

program a code to the TV device. However, your

circumstances may be different.

4. Programming the MX-500

to Control Your Components