User Manual

Installation
Version 4 3-1 04/02/04
3 Installation
3.1 Safety Regulation
3.1.1 FCC Requirements
FCC Regulations state that:
1. Radio Transmitters may be tuned or adjusted only by persons
holding a general class commercial radiotelephone operator’s
license or by personnel working under their immediate
supervision.
2. The RF power output of a radio transmitter should be no more
than that required for satisfactory technical operation
considering the area to be covered and local conditions.
3. The frequency, deviation, and power of a base station
transmitter must be maintained within specified limits. It is
recommended that these three parameters be checked before
the station is placed in service.
4. The power input to the final radio frequency stage shall not
exceed the maximum figure specified on the current station
authorization.
This power input shall be measured and the results record:
a. When the transmitter is initially installed.
b. When any change is made in the transmitter, which may
increase the power input.
c. At intervals not to exceed one (1) year.
3.1.2 FCC Interference Warning
FCC Regulations state that: This equipment generates,
uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instruction manual,
may cause interference to radio communications. As
temporarily permitted by regulation, it has not been tested for
compliance with the limits for Class A computing devices
pursuant to Sub-part J of Part 15 of FCC Rules, which are
designed to proved reasonable protection against such
interference. Operation of this equipment in a residential
area is likely to cause interference in which case the user, at
owner’s expense, will be required to correct the interference.