User Manual

Installation
Version 4 3-4 04/02/04
3.2 Installation Procedure
1. Connect antenna to the Extend-A-Page transmitter. The Transmitter
unit is equipped with a N Female connector.
2. Connect a power cable from the transmitter unit to the AC power
outlet. Ensure that the AC outlet is grounded.
3. Connect the paging terminal or controller outputs to the DB9 connector
labeled transmitter interface.
4. If an Extend-A-Page receiver is used, use the DB9 connector for
interface to the Extend-A-Page transmitter. This
NOTE:
Use cable supplied for this connection.
5. Turn power ‘ON’ to the transmitter unit and the “SYS” LED indicator will
turn ‘GREEN’. This ensures that the EAP Unit is good and the RF
exciter has been correctly programmed. Absence of the green LED
indicates a system malfunction, check control boards are correctly
seated and all cables are pushed in.
6. The Extend-A-Page transmitter unit should be under power for a
period of 24 hours before any frequency adjustment is made.
The “Frequency Adjust” potentiometer is accessible near the antenna
connector.