User Manual
Table Of Contents
- Important Safety Notices
- Product Overview
- Basic Installation
- 2.1 Safety Measures
- 2.2 System Requirements
- 2.3 Deployment Models
- 2.3.1 Lightning Strike and Surge Protection
- 2.3.2 Grounding Protection
- 2.4 Hardware Installation
- 2.4.1 Choosing a Location
- 2.4.2 Grounding the CPE
- 2.4.3 Preparing the Outdoor LAN Cable
- 2.5 Aligning the Antenna
- 2.5.1 Using the Optional Signal Detector
- 2.6 Connecting the CPE to the LAN
- 2.6.1 Connecting the CPE to a Stand Alone PC
- 2.7 Completing the Installation
- 2.8 Installing the Antennas
- 2.9 Powering Off the CPE
- 2.10 Rebooting the CPE
- 2.11 Resetting the CPE
- Features and Web GUI Configuration
- 3.1 Logging In
- 3.2 Using the System Page
- 3.2.1 LAN Settings
- 3.2.2 NTP Settings
- 3.2.3 VLAN Tagging
- 3.3 Using the Band Page
- 3.3.1 Band Settings
- 3.3.2 FFT Settings
- 3.4 Using the Security Page
- 3.4.1 Changing Login Details
- 3.4.2 PKM Settings
- 3.5 Using the Status Page
- 3.5.1 System Status
- 3.5.2 LAN Status
- 3.5.3 Forwarding Status
- 3.5.4 Connection Status
- 3.6 Using the Tools Page
- 3.6.1 Upgrading the Firmware
- 3.6.2 Restoring Factory Defaults
- 3.6.3 Rebooting the CPE
- Troubleshooting
- Glossary
- Index
10 Deployment Models
Basic Installation
2
DIRECT STRIKE PROTECTION
A direct lightning strike, as the name suggests, describes an electrical dis-
charge directly to a lightning rod or the CPE itself.
The CPE must be installed within the lightning rod’s protection umbrella or have
sufficient grounding and surge protection installed.
See Grounding Protection on page 12 for more information on grounding spec-
ifications.
DISCLAIMER: CONSULT A QUALIFIED PROFESSIONAL TO
DETERMINE THE CORRECT PROTECTION METHOD FOR YOUR
INSTALLATION.
!
Direct Strike
w/o lightning rod
Outdoor CPE
Ground cable
lightning
lightning
Ground cable
Direct Strike
w/ lightning rod
Lightning
Rod
Outdoor CPE
Protection
Umbrella