User Manual
Table Of Contents
- Important Safety Notices
- Product Overview
- Basic Installation
- 2.1 Safety Measures
- 2.2 System Requirements
- 2.3 Deployment Models
- 2.3.1 Lightning Strike and Surge Protection
- 2.3.2 Grounding Protection
- 2.4 Hardware Installation
- 2.4.1 Choosing a Location
- 2.4.2 Grounding the CPE
- 2.4.3 Preparing the Outdoor LAN Cable
- 2.5 Aligning the Antenna
- 2.5.1 Using the Optional Signal Detector
- 2.6 Connecting the CPE to the LAN
- 2.6.1 Connecting the CPE to a Stand Alone PC
- 2.7 Completing the Installation
- 2.8 Installing the Antennas
- 2.9 Powering Off the CPE
- 2.10 Rebooting the CPE
- 2.11 Resetting the CPE
- Features and Web GUI Configuration
- 3.1 Logging In
- 3.2 Using the System Page
- 3.2.1 LAN Settings
- 3.2.2 NTP Settings
- 3.2.3 VLAN Tagging
- 3.3 Using the Band Page
- 3.3.1 Band Settings
- 3.3.2 FFT Settings
- 3.4 Using the Security Page
- 3.4.1 Changing Login Details
- 3.4.2 PKM Settings
- 3.5 Using the Status Page
- 3.5.1 System Status
- 3.5.2 LAN Status
- 3.5.3 Forwarding Status
- 3.5.4 Connection Status
- 3.6 Using the Tools Page
- 3.6.1 Upgrading the Firmware
- 3.6.2 Restoring Factory Defaults
- 3.6.3 Rebooting the CPE
- Troubleshooting
- Glossary
- Index
Hardware Installation 13
Basic Installation
2
2.4 Hardware Installation
This section describes the proper steps required to install the CPE, and to align
the antenna.
2.4.1 Choosing a Location
To make optimal use of the CPE, a suitable location is important. The range of
the CPE largely depends upon the position of the antenna. It is recommended
that an overall survey be performed, observing the following requirements,
before installing the CPE:
• Do not place the CPE near the floor or near metal objects, such as drain
pipes
• The location must allow easy disconnection of power to the CPE if neces-
sary
• Air must be able to flow freely around the hardware
• The CPE unit must be kept away from vibration and excessive heat
• The installation must conform with national and local electrical codes
WARNING: Before installing and using this product, see Important
Safety Notices
on page i of this manual.
NOTE: Be sure to read the Release Notes file on the product CD as it
contains software version and driver information that may not have been
available when this document was produced.
WARNING
N te