User Manual
Table Of Contents
- Important Safety Notices
- Product Overview
- Basic Installation
- 2.1 Safety Measures
- 2.2 System Requirements
- 2.3 Deployment Models
- 2.3.1 Lightning Strike and Surge Protection
- 2.3.2 Grounding Protection
- 2.4 Hardware Installation
- 2.4.1 Choosing a Location
- 2.4.2 Grounding the CPE
- 2.4.3 Preparing the Outdoor LAN Cable
- 2.5 Aligning the Antenna
- 2.5.1 Using the Optional Signal Detector
- 2.6 Connecting the CPE to the LAN
- 2.6.1 Connecting the CPE to a Stand Alone PC
- 2.7 Completing the Installation
- 2.8 Installing the Antennas
- 2.9 Powering Off the CPE
- 2.10 Rebooting the CPE
- 2.11 Resetting the CPE
- Features and Web GUI Configuration
- 3.1 Logging In
- 3.2 Using the System Page
- 3.2.1 LAN Settings
- 3.2.2 NTP Settings
- 3.2.3 VLAN Tagging
- 3.3 Using the Band Page
- 3.3.1 Band Settings
- 3.3.2 FFT Settings
- 3.4 Using the Security Page
- 3.4.1 Changing Login Details
- 3.4.2 PKM Settings
- 3.5 Using the Status Page
- 3.5.1 System Status
- 3.5.2 LAN Status
- 3.5.3 Forwarding Status
- 3.5.4 Connection Status
- 3.6 Using the Tools Page
- 3.6.1 Upgrading the Firmware
- 3.6.2 Restoring Factory Defaults
- 3.6.3 Rebooting the CPE
- Troubleshooting
- Glossary
- Index
16 Hardware Installation
Basic Installation
2
4. Repeat the process for the second securing ring.
2.4.2 Grounding the CPE
To ensure proper grounding, attach a ground wire of at least 26 AWG stranded
to the CPE as shown:
See Grounding Protection on page 12 for termination information.
NOTE: The serial number is required to obtain support from the vendor.
Maintain this information in a safe place for future reference.The serial
number is on the bottom label of the CPE and on the side of the package.
If technical assistance is required, the serial number is necessary.
WARNING: Use proper wire grounding techniques in accordance with
local electric codes:
The cable ground shall be connected to the grounding sys-
tem of the building, as close to the point of cable entry as is
practical.
N te
WARNING
To regulation
grounding