User Manual
Table Of Contents
- Important Safety Notices
- Product Overview
- Basic Installation
- 2.1 Safety Measures
- 2.2 System Requirements
- 2.3 Deployment Models
- 2.3.1 Lightning Strike and Surge Protection
- 2.3.2 Grounding Protection
- 2.4 Hardware Installation
- 2.4.1 Choosing a Location
- 2.4.2 Grounding the CPE
- 2.4.3 Preparing the Outdoor LAN Cable
- 2.5 Aligning the Antenna
- 2.5.1 Using the Optional Signal Detector
- 2.6 Connecting the CPE to the LAN
- 2.6.1 Connecting the CPE to a Stand Alone PC
- 2.7 Completing the Installation
- 2.8 Installing the Antennas
- 2.9 Powering Off the CPE
- 2.10 Rebooting the CPE
- 2.11 Resetting the CPE
- Features and Web GUI Configuration
- 3.1 Logging In
- 3.2 Using the System Page
- 3.2.1 LAN Settings
- 3.2.2 NTP Settings
- 3.2.3 VLAN Tagging
- 3.3 Using the Band Page
- 3.3.1 Band Settings
- 3.3.2 FFT Settings
- 3.4 Using the Security Page
- 3.4.1 Changing Login Details
- 3.4.2 PKM Settings
- 3.5 Using the Status Page
- 3.5.1 System Status
- 3.5.2 LAN Status
- 3.5.3 Forwarding Status
- 3.5.4 Connection Status
- 3.6 Using the Tools Page
- 3.6.1 Upgrading the Firmware
- 3.6.2 Restoring Factory Defaults
- 3.6.3 Rebooting the CPE
- Troubleshooting
- Glossary
- Index
26 Connecting the CPE to the LAN
Basic Installation
2
2.6.1 Connecting the CPE to a Stand Alone PC
To connect the CPE directly to a computer, perform the following steps:
1. Connect the CAT5 Ethernet cable to the DATA OUT port on the PoE, and a
standard Ethernet cable to the DATA IN port.
2. Connect the Ethernet cable from the DATA IN port to the computer as
shown.
3. Connect the PoE to an electrical outlet.
CAUTION: THE PoE (PSE) MUST BE INSTALLED INDOORS.
!
DATA OUT
DATA IN
CAT5 Ethernet
Cable
Ethernet
Cable
DATA OUT
DATA IN