User Manual
Table Of Contents
- Important Safety Notices
- Product Overview
- Basic Installation
- 2.1 Safety Measures
- 2.2 System Requirements
- 2.3 Deployment Models
- 2.3.1 Lightning Strike and Surge Protection
- 2.3.2 Grounding Protection
- 2.4 Hardware Installation
- 2.4.1 Choosing a Location
- 2.4.2 Grounding the CPE
- 2.4.3 Preparing the Outdoor LAN Cable
- 2.5 Aligning the Antenna
- 2.5.1 Using the Optional Signal Detector
- 2.6 Connecting the CPE to the LAN
- 2.6.1 Connecting the CPE to a Stand Alone PC
- 2.7 Completing the Installation
- 2.8 Installing the Antennas
- 2.9 Powering Off the CPE
- 2.10 Rebooting the CPE
- 2.11 Resetting the CPE
- Features and Web GUI Configuration
- 3.1 Logging In
- 3.2 Using the System Page
- 3.2.1 LAN Settings
- 3.2.2 NTP Settings
- 3.2.3 VLAN Tagging
- 3.3 Using the Band Page
- 3.3.1 Band Settings
- 3.3.2 FFT Settings
- 3.4 Using the Security Page
- 3.4.1 Changing Login Details
- 3.4.2 PKM Settings
- 3.5 Using the Status Page
- 3.5.1 System Status
- 3.5.2 LAN Status
- 3.5.3 Forwarding Status
- 3.5.4 Connection Status
- 3.6 Using the Tools Page
- 3.6.1 Upgrading the Firmware
- 3.6.2 Restoring Factory Defaults
- 3.6.3 Rebooting the CPE
- Troubleshooting
- Glossary
- Index
3
Features and Web GUI
Configuration
This chapter contains a list of features and connection configuration specifica-
tions as well as information on the Web-based Graphical User Interface (GUI).
The CPE’s GUI enables quick and simple setup, and the configuration of the
following options:
• Connection of the CPE to a WiMAX base station
• Network setting changes, such as internal IP address, IP address pool,
DHCP settings, and more
• Internal password change
• Default settings reset
• Firmware updates