User Manual
Table Of Contents
- Important Safety Notices
- Product Overview
- Basic Installation
- 2.1 Safety Measures
- 2.2 System Requirements
- 2.3 Deployment Models
- 2.3.1 Lightning Strike and Surge Protection
- 2.3.2 Grounding Protection
- 2.4 Hardware Installation
- 2.4.1 Choosing a Location
- 2.4.2 Grounding the CPE
- 2.4.3 Preparing the Outdoor LAN Cable
- 2.5 Aligning the Antenna
- 2.5.1 Using the Optional Signal Detector
- 2.6 Connecting the CPE to the LAN
- 2.6.1 Connecting the CPE to a Stand Alone PC
- 2.7 Completing the Installation
- 2.8 Installing the Antennas
- 2.9 Powering Off the CPE
- 2.10 Rebooting the CPE
- 2.11 Resetting the CPE
- Features and Web GUI Configuration
- 3.1 Logging In
- 3.2 Using the System Page
- 3.2.1 LAN Settings
- 3.2.2 NTP Settings
- 3.2.3 VLAN Tagging
- 3.3 Using the Band Page
- 3.3.1 Band Settings
- 3.3.2 FFT Settings
- 3.4 Using the Security Page
- 3.4.1 Changing Login Details
- 3.4.2 PKM Settings
- 3.5 Using the Status Page
- 3.5.1 System Status
- 3.5.2 LAN Status
- 3.5.3 Forwarding Status
- 3.5.4 Connection Status
- 3.6 Using the Tools Page
- 3.6.1 Upgrading the Firmware
- 3.6.2 Restoring Factory Defaults
- 3.6.3 Rebooting the CPE
- Troubleshooting
- Glossary
- Index
38 Using the Band Page
Features and Web GUI Configuration
3
3.3 Using the Band Page
The Band page is used to set WiMAX scan frequencies as provided by the ISP,
and to set the Fast Fourier Transform rate.
3.3.1 Band Settings
Band Settings are used to enter the frequencies and bandwidths supplied by
the ISP, allowing the CPE to connect successfully to the BTS. The Scanning
List describes the bandwidths and frequencies currently scanned for connec-
tion.
To enter band settings manually, perform the following steps:
1. Select a bandwidth from the drop down menu as supplied by the ISP.
2. Enter a frequency between 2500000 and 2700000 KHz or 3400000 and
3600000 KHz as supplied by the ISP.
3. Select the Frame Duration in milliseconds as supplied by the ISP.
4. Click Add Entry to refresh the Scanning List.
5. Click Save Settings.
NOTE: The operating frequency band is dependent on the product
purchased.
N te