User Manual
Table Of Contents
- Important Safety Notices
- Product Overview
- Basic Installation
- 2.1 Safety Measures
- 2.2 System Requirements
- 2.3 Deployment Models
- 2.3.1 Lightning Strike and Surge Protection
- 2.3.2 Grounding Protection
- 2.4 Hardware Installation
- 2.4.1 Choosing a Location
- 2.4.2 Grounding the CPE
- 2.4.3 Preparing the Outdoor LAN Cable
- 2.5 Aligning the Antenna
- 2.5.1 Using the Optional Signal Detector
- 2.6 Connecting the CPE to the LAN
- 2.6.1 Connecting the CPE to a Stand Alone PC
- 2.7 Completing the Installation
- 2.8 Installing the Antennas
- 2.9 Powering Off the CPE
- 2.10 Rebooting the CPE
- 2.11 Resetting the CPE
- Features and Web GUI Configuration
- 3.1 Logging In
- 3.2 Using the System Page
- 3.2.1 LAN Settings
- 3.2.2 NTP Settings
- 3.2.3 VLAN Tagging
- 3.3 Using the Band Page
- 3.3.1 Band Settings
- 3.3.2 FFT Settings
- 3.4 Using the Security Page
- 3.4.1 Changing Login Details
- 3.4.2 PKM Settings
- 3.5 Using the Status Page
- 3.5.1 System Status
- 3.5.2 LAN Status
- 3.5.3 Forwarding Status
- 3.5.4 Connection Status
- 3.6 Using the Tools Page
- 3.6.1 Upgrading the Firmware
- 3.6.2 Restoring Factory Defaults
- 3.6.3 Rebooting the CPE
- Troubleshooting
- Glossary
- Index
48 Using the Tools Page
Features and Web GUI Configuration
3
3.6.2 Restoring Factory Defaults
The Restore Factory Defaults screen is used to restore the CPE to the factory
supplied defaults.
To reset the CPE to the factory defaults, click Reset and follow the onscreen
prompts.
WARNING: All settings changes are lost when factory defaults are
restored.
WARNING