User Manual
Table Of Contents
- Important Safety Notices
- Product Overview
- Basic Installation
- 2.1 Safety Measures
- 2.2 System Requirements
- 2.3 Deployment Models
- 2.3.1 Lightning Strike and Surge Protection
- 2.3.2 Grounding Protection
- 2.4 Hardware Installation
- 2.4.1 Choosing a Location
- 2.4.2 Grounding the CPE
- 2.4.3 Preparing the Outdoor LAN Cable
- 2.5 Aligning the Antenna
- 2.5.1 Using the Optional Signal Detector
- 2.6 Connecting the CPE to the LAN
- 2.6.1 Connecting the CPE to a Stand Alone PC
- 2.7 Completing the Installation
- 2.8 Installing the Antennas
- 2.9 Powering Off the CPE
- 2.10 Rebooting the CPE
- 2.11 Resetting the CPE
- Features and Web GUI Configuration
- 3.1 Logging In
- 3.2 Using the System Page
- 3.2.1 LAN Settings
- 3.2.2 NTP Settings
- 3.2.3 VLAN Tagging
- 3.3 Using the Band Page
- 3.3.1 Band Settings
- 3.3.2 FFT Settings
- 3.4 Using the Security Page
- 3.4.1 Changing Login Details
- 3.4.2 PKM Settings
- 3.5 Using the Status Page
- 3.5.1 System Status
- 3.5.2 LAN Status
- 3.5.3 Forwarding Status
- 3.5.4 Connection Status
- 3.6 Using the Tools Page
- 3.6.1 Upgrading the Firmware
- 3.6.2 Restoring Factory Defaults
- 3.6.3 Rebooting the CPE
- Troubleshooting
- Glossary
- Index
Index
A
Antenna
Adjusting 21
Alignment 19
Signal Strength 20
B
Band
Changing 38
Band Settings 38
C
Changing 40
Channel and Frequency
Band Settings 38
FFT Settings 39
Choosing a Location 13
Conformance
IEEE 802.16 1
R&TTE v
UL Information v
WEEE v
Conformance Documents iii
Connection
LAN 24
Stand Alone PC 26
Connection Status 45
CPE
Powering Down 29
Resetting 29
D
Deployment Models 8
DHCP 35
F
Factory Defaults 48
Fast Fourier Transform 39
FFT Settings 39
Firmware 46
Forwarding Status 44
G
GUI Password 40
I
Installation
Deployment 8
Grounding 16
Hardware 13
LAN Connection 24
Location 13
Pole Mounting 15
Safety Measures 7
Stand Alone PC Connection 26
System Requirements 7
Wall Mounting 14