User's Manual

No part of this documentation may be reproduced in any form or by any means or used to make any derivative work

(such as translation, transformation, or adaptation) without written permission from the copyright owner.

All the other trademarks and registered trademarks are the property of their respective owners.

Statement of Conditions

We may make improvements or changes in the product described in this documentation at any time. The

information regarding to the product in this manual are subject to change without notice.

We assumes no responsibility for errors contained herein or for direct, indirect, special, incidental or consequential

damages with the furnishing, performance, or use of this manual or equipment supplied with it, even if the suppliers

have been advised of the possibility of such damages.

Electronic Emission Notices

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired

operation.

FCC INFORMATION

The Federal Communication Commission Radio Frequency Interference Statement includes the following

paragraph:

The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instruction, may cause harmful interference to radio communication. However,

there is no grantee that interference will not occur in a particular installation. If this equipment dose cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on , the user

is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

The user should not modify or change this equipment without written approval form Airvast. Modification could void

authority to use this equipment.

Notice

The changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is

permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure

requirements and void user’s authority to operate this device.

This device complies with FCC radiation exposure limits set forth for an uncontroller environment and can

only be used with Notebook computer with PCMICA slots on either side of notebook computer. This

transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.