User's Manual

OWNERS INSTRUCTIONS

The USI-2413 has been assembled for the purpose of meeting the American

Disabilities Act requirements for visual signaling devices for the hearing impaired.

This kit contains (1) Model USI-1213 AC Smoke Alarm, (1) Model USI-960 Relay

Module and (1) Model USI-2177 177 Candela Strobe light.

INSTALLATION

The following wiring diagram can be used as a reference when installing this kit

and wiring the three units together.

IMPORTANT

Prior to installation, you must thoroughly read and understand each individual

component manual.

288-3272-00

INSTALLATION

Installation of this unit must conform to the electrical codes in

your area; Article 760 of the National Electrical Code, NFPA 72,

101; SBC (SBCCI); UBC (ICBO); NBC (BOCA): OTFDC (CABO),

and any other local or building codes that may apply. Wiring and

installation must be performed by a licensed electrician. Failure

to follow these guidelines may result in injury or property damage.

This unit must be powered by a 24-hour, 120V AC 60Hz circuit. Be

sure the circuit cannot be turned off by a switch, dimmer or ground

fault circuit interrupter. Failure to connect this unit to a 24-hour

circuit may prevent it from providing constant protection.

Smoke & Fire Alarm

Signaling Device Kit for

Hearing Impaired

MODEL USI-2413

Printed in China

11407 Cronhill Drive, Suite A

Owings Mills, Maryland 21117 USA

Visit Us on the Web! www.SmokeAlarms.com