User's Manual

3.4. NOISE PROBLEM
How can I recognize a noise problem?
 Externally: When you turn on your system:
• The system shows a high amount of noise in the LED bar.
• The detection might be poor.
 Laptop:
• In the scope you will see high amount of noise, in the 4 buffers.
How can I solve a noise problem?
 Try to locate the source of noise:
• Turn off all electrical equipment in the area. If the noise disappears, start turning all the electrical
equipment ONE BY ONE till you get noise again.
• Other way to locate the source of noise is moving the Receiver antenna while at the same time you are
looking to the LED bar or the software. See how the orientation of the Receiver antenna affects the
amount of noise and you will finally find the source.
 Then you have to neutralize the source of noise. (It might be related with bad synchro, please check
procedure in Section 5.7.5. DISCOVERY TOOL) Other techniques are:
• Swap Transceiver antenna by Receiver antenna position.
• Ground the noisy device correctly or try to put it as far as possible from the Receiver antenna.
• Use advanced noise techniques 'New Noise fighting algorithms'
11