User's Manual

 When you click on 'ON' button , a new scope window will appear:
• System transmission blocks (A, B, C) will be represented in the negative area in green colour
• Other transmission blocks are represented in red colour.
• Noise is yellow colour
• Signal detection blocks are represented in purple colour in the negative area (always after system
transmission blocks)
 Zoom for AXIS Y.
Select Auto or fixed to set the Y maximum level.
 Zoom for AXIS X.
Select Normal to display 3 blocks (A, B and C) or Blocks in case you want to display one
only Block (A, B or C) with more resolution. (This option is available for versions 4.C0 or
higher)
 AM 58kHz Timing
Delay:
Change the delay manually to synchronize the transmission with other systems
around. (0.2ms is default time)
TX Blocks
Enable/disable transmission blocks. It is recommended to have three blocks
enabled unless you have tag detection signal on any of these blocks too high. In
this case, you can disable the involved block.
RX Signal Level
This is the level for tag signal for each TX Block (A, B C)
50