User's Manual
Table Of Contents
- 1. G10V SYSTEM OVERVIEW
- 2. HARDWARE
- 3. QUICK TUNING
- 4. CONFIGURATION
- 5. SOFTWARE
- 6. SAFETY AND DECLARATIONS
5.8. RECEIVER TAB
Transceiver antenna is also a Receiver antenna, so it has its own receiver side.
Each Transceiver antenna is able to support 2 Receiver antennas.
Selecting 'Transceiver' allows selecting parameters for receiver side of Transceiver antenna
Selecting 'Red Channel' allows selecting parameters for the Receiver Antenna connected to the red
connector on the Transceiver board.
Selecting 'Grey Channel' allows selecting parameters for the Receiver Antenna connected to the grey
connector on the Transceiver board.
5.8.1. GAIN
Gain feature is used to adjust the receiver sensitivity to get the best reception signal.
In order to adjust Gain, simply select the value until you get the required detection.
5.8.2. THRESHOLD
Threshold feature is the signal level at which each receiver will trigger an alarm.
If you need higher threshold, then increase the Multiplier. With higher threshold detection is reduced. The
system is less sensitive and more quantity of signal will be needed from the tag to trigger an alarm.
It is recommended, for maximum sensitivity to keep the Threshold at minimum (18 dB) & Multiplier=1.
In order to adjust Threshold, simply select the value until you get the required detection
54