User's Manual

5.10.3. ALARM TYPES
 Standard alarm for a 58 kHz tag. Click on the icon to enable or disable sound alarm.
 Relay:
• When an alarm occurs, the alarm
closes a relay and triggers anything
connected to it.
• RELAY SPECIFICATIONS: 240V &
250mA.
• Normal Open(NO) & Normal
Close(NC) contacts
 Light Options:
• Select the number of flashes. This feature is available for each antenna.
• Select 'Change all at once' to apply changes in all antennas
 This alarm occurs when system finds an inhibitor of 58 kHz
 Check ON/OFF to enable or disable alarm detection. (Disable by default)
 Enable / disable alarm sound.
 Select threshold level when activating this alarm (>7 recommended).
 This alarm occurs when a 58kHz label/tag is located near the antennas
 Check ON/OFF to enable or disable alarm detection. (Disable by default)
 Enable / disable alarm sound.
 Synchro Signal: It is used to synchronize transmission blocks with zero crossing power line.
 The signal comes out from the Power Supply and goes to the Transceiver Board Supply.
 Enabled by default. When Power Synchro Signal fails, system would not run properly and alarm event
occurs.
 This alarm occurs on entrance people detection
 Disable by default. Click on the icon to enable or disable In-counting sound
 This alarm occurs on exit people detection
 Disable by default. Click on the icon to enable or disable Out-counting sound
63