User's Manual

3. QUICK TUNING
3.1. QUICK INSTALLATION
3.1.1. PREVIOUS
 Always connect the system to clean power lines (No other electrical devices connected)
 In order to avoid damaging the electronics, do not place any TURNED OFF antenna near a TURNED ON
Transceiver antenna. Please keep the minimum distance, not less than 50cm
 Do not fix the system to the floor before testing its performance FIRST!
 Do not place Receiver and Power line (220Vac/110Vac) cables along the same route.
 Please Read this manual BEFORE installing systems!
3.1.2. SYSTEM INSTALLATION
 Check cabling / connection needs according to the kind of installation. (See Section 4. CONFIGURATION).
Check all the material is ready.
 Place the system in the installation area. (DO NOT fix the system to the floor).
 Turn the system ON, and connect to the system (Follow Section 5. SOFTWARE)
 Check Electrical Noise, Synchro, TX Status, etc.… check everything is normal.
 Stabilize external electrical noise to the minimum.
 Check Section 1.3. TABLE: SYSTEM / DETECTION / NOISE to define the maximum detection distance.
 If any modifications, save parameters.
 Disconnect your laptop and observe the system during some time making several detection tests (buzzer
can be disabled to not cause disturbance).
 If OK, fix the system to the floor , if not OK, see Section 3.2. TROUBLESHOOTING
You are done!
3.2. TROUBLESHOOTING
3.2.1. NO DETECTION
 Try with other tag
 Rise Gain (Up to 2-3 LEDS)
 Lower Threshold
 See Section 3.4. NOISE PROBLEM
 See Section 3.3. SYNCHRONIZATION PROBLEM
 See Section 3.5. DEAD TRANSMITTER
 See Section 3.6. DEAD RECEIVER
3.2.2. TOO MUCH DETECTION
 Lower Gain
 Rise Threshold
3.2.3. FALSE ALARM
 Look for TAGS near the antennas
 See Section 3.7. FALSE ALARM (OR UNKNOWN ALARM)
3.2.4. MAKES OTHER SYSTEMS FALSE ALARM
 See Section 3.3. SYNCHRONIZATION PROBLEM
9