User's Manual

ManualsBrandsUniversal Surveillance Systems ManualsElectronics8.2 MHz Mirage System

MONO82_USR_MAN_REV_A

This document was created to provide intended recipient documentation of requested device for technician purposes only. Any other usage of this document is an illegal and unlawful act. This document is a confidential and proprietary

document of Universal Surveillance Systems and consist of i nformation what can be protected by copyrights or the others intellectual property protection instruments of the others subjects. All other informa tion, what are not generally

known ones, is an intellectual property of Universal Surveillance Systems. This document including any and all attachments hereto is intended solely to be used by individual or entity to which it is addressed. If the reader of this

document is not the intended recipient, or an employee or agent responsible for delivering this document to its intended recipient, you are herewith notified that any dissemination, distribution, copying or retention of this document

or the informa tion contained her ein is strictly prohibited. If you have received this document in error, please notify us at service@un ivser aleas.c om i mmediately and permanentl y delete or/and destroy the original and any copy or

printout thereof.

RX channels - Shows received signal on eight channels. Frequency of each channel

depends on parameter setting of "Use sweep" and range of minimal and maximal

frequency.

If it is "Use sweep" turned ON,

frequencies

are

mathematically generated

from

minimal to maximal value. If it is "Use sweep" turned OFF, all of eight channels has the

same

value. Every channel

can

deactivated by the

checkbox.

Test and testing - For testing purposes. Capture values from the electronic board and

report on them. Bias values should be

around 2100, different values indicate

error.

6.5 SYNC

Sync - Takes down one period of mains frequency. Green rectangle represent bursts that

system

transmits.

Red signal

represents everything

else, like

environmental

or static noise,

other systems, interference etc. This signal helps, when you want to synchronize systems

to avoid them from interference with each other. If you want display actual received

signal, choose “Automatic read” checkbox

and click on “Read array”

button.

D/A

Shows different types

of signals

used mostly for testing

purposes.

7. QUICK INTALLATION GUIDE

This section is meant to describe the basic steps for installing the RF system in a

standard environment. It is not meant to troubleshoot, but only to show the necessary

steps in sequential order.

7.1 PRE-INSTALLATION

(A) Review User Manual and Rules of Installation.

(B) Install your PC latest version of RF Software.