Installation Guide

Walk-in Wall Surround Installation
1 Oakwood Blvd STE200 Hollywood, FL 33020 • 305-330-1146
INSTALLATION
STARTING POINT
Measure the available space. The SURROUND Unit comes as two (2) 60” by 60” finished sheets ( or 3 sheets
for tubs 32” or wider). Take measurements of the back wall and both left and right flanking walls.
As the SURROUND Unit is crafted as a one size fits all unit it will up to your installed to measure and cut the
SURROUND Panels to size.
Note: Before starting it is crucial first clean and dry the existing tiled wall. Clean and dry the surface of your
existing wall. Make sure to remove any soap, oil, or greasy residue before proceeding with the SURROUND
Installation.
It is also critical that the bathtub itself is properly leveled. An unleveled bathtub will cause measurements
and cuts made on the SURROUND Panels to not fit properly due to miss alignment.
A
A
B
Measure the area of the back wall and
and cut one of the Wall Surround sheets
to size. (Max size available 60 by 60 in.)
B
Do the same for the acking wall. Measure both
the left and right walls before making the cut as
both wall covers will be provided from the second
60 by 60 in. Wall Surround sheet.
Note: Make sure to account the tile lange if one is present
on your bathtub.