Installation Guide

Walk-in Wall Surround Installation
INSTALLATION
1 Oakwood Blvd STE200 Hollywood, FL 33020 • 305-330-1146
TRIMMING THE BULLNOSE BEND
The SURROUND Panels will ship with an approximate 1” lip (also
known as a bullnose bend) all around the edge. It will be up to the
installer’s discretion to come up with the perfect length needed for
the project.
Mark the sheet with a cut line and proceed cut along said line. The
usual tool for this particular job would be a jigsaw. If using a jigsaw
a carbide edged blade would be our recommendation.
Shower Wall
Wall Surround with Trimmed Bend
Trimmed away portion.
For this example a half inch of the bullnose bend
has been left. This allow for the end of the wall
surround sheet to wrap over the bathroom wall’s
corner edge. The amount to be trimmed is wholly
up to you taste. The entire bend/lip could be
removed if desired leaving the sheet completely
ushed with the corner’s edge. It’s up to you.