Instructions / Assembly
Table Of Contents
- THANK YOU FOR CHOOSING Spa World Corp ®
- CONTACT INFORMATION
- Product Registration*
- UNPACKING THE UNIT
- PRE-INSTALLATION*
- INSTALLATION PREPARATION
- electrical PREPARATION
- INSTALLATION PROCEDURES
- DRAIN CONNECTION
- Connecting the Autodrain
- Installation and extension panels
- Faucet installation
- operating safety instructions
- operating instructions
- CLEANING AND MAINTENANCE
- warranty
- RETURN POLICY
Page 21
WALK-IN TUB MANUAL
OPERATING INSTRUCTIONS
5701 NW 35 Avenue Miami, FL 33142 • Phone 877-360-4454 • Fax 866-560-1060
CLEANING AND MAINTENANCE
Pump and pipe circulation systems should be flushed before first use and on a monthly basis when product is under normal use.
Below are the recommended procedures for cleaning:
• Do not run whirlpool dry. Fill the tub with hot water 2-3 inches above the jets and add 2-3 teaspoons of low foaming
detergent such as dishwashing machine detergent
• Turn on whirlpool system and run for 10 minutes
• Drain tub completely
• Fill tub with cold water above jets
• Turn on whirlpool system and run for 15 minutes
• Drain tub completely
• Cleaning the suction cover: Clean and remove any hair or lint from the suction cover (see image below). On a monthly basis,
unscrew the suction cover and clean away any hair, lint or debris from the cover and housing, then remount the cover in place. Some
suctions are not designed to be removed; only suctions that have screws on the cover, visible from the inside of the tub, can be
removed.
WARNING! NEVER OPERATE THE UNIT WITH THE SAFETY SUCTION COVER OFF.
SUCTION COVER