Users Manual

Wall-mount sticker
Drill here
Drill here
Drill here
Follow the calibration tails,
paste the sticker horizontally on the wall
1.4m calibration tail
Wall
Pre-stripping
Wiring instruction (set power wire as an example, the rest can be done in the same manner)
Take off the protection circle
on the pre-stripping wire of
strip cable
Use tool like scissor to strip
(power) cable, and expose the
metal wire
Paste hole papers, and keep the horizontal line parallel with the ground and the red line 1.4m
distance to the ground. Drill 3 screw holes on the wall according to the reminder of hole paper,
drill 1-2 outlet holes according to wiring needs, and use expansion pipe in the parts to knock
into the hole.
According to the support position, punch out the green
socket with connected wires from the outlet hole. Punch
out the RESET cable and HDMI cable from the hole as well.
Move the support to align the 3 holes on it with holes on the wall, and use the screws to fix the
support on the wall.
Twist the countersunk screw around the device, align the slot at the device bottom with the
hook at the support bottom, use hexagon tool or hexagonal screwdriver to tighten the
countersunk screw follow the direction indicated, to complete the installation.
Attention: If the polarity of the power cable is connected in opposite direction, then the device will not be booted; if connected in
right direction, then the device will be normally booted; power adapter requires DC12-16V, 2A
Twist the positive pole of the power cable with
corresponding metal wire, and use black tape to
cover the metal part
Attention: When apply the air-cooling support, connect the fan wires with interface of power strip in
this step, as shown on the picture, insert and fasten.
Align the green socket with interface on the device back, and insert.
Attention: If the wall has hard foundation, self-tapping screws shall be used together with expansion pipe; if the wall has soft
foundation, use self-tapping screws directly.
M2 countersunk
screw
Steps
Wall-mount sticker
Drill here Drill here
Drill here
Follow the calibration tails,
paste the sticker horizontally on the wall
1.4m calibration tail
Wall-mount sticker
Drill here
Drill here
Drill here
Follow the calibration tails,
paste the sticker horizontally on the wall
1.4m calibration tail
Outlet hole
Expansion pipe screw
Ground
Wall
Align direction Insert, fasten Side sketch map Plug out
Press here
Wall-mount sticker
Drill here
Drill here
Drill here
Follow the calibration tails,
paste the sticker horizontally on the wall
1.4m calibration tail
Slot
SlotSlot