Users Manual

Wiring instruction (set power wire as an example, the rest can be done in the same manner)
Take off the protection circle
on the pre-stripping wire of
socket cable
1
6
4
2
Paste hole papers, and keep the horizontal line parallel with the ground and the red line 1.4m
distance to the ground. Drill 3 screw holes on the wall according to the reminder of hole paper,
drill 2 outlet holes according to wiring needs, please use expansion pipe in the parts to knock
into the hole if for wall with hard foundation.
3
According to the support position, punch out the white
socket with connected wires from the outlet hole.
Move the support to align the 3 holes on it with holes on the wall, and use the screws to fix
the support on the wall.
5
Align the white socket with interface on the device back, and insert.
Twist the countersunk screw around the device, align the slot at the device bottom with the
hook at the support bottom, use hexagon tool or hexagonal screwdriver to tighten the
countersunk screws follow the direction indicated, to complete the installation.
Attention: If the polarity of the power cable is connected in opposite direction, then the device will not be booted; if connected in
right direction, then the device will be normally booted; power adapter requires DC12-16V, 2A
Attention: If the wall has hard foundation, self-tapping screws shall be used together with expansion pipe; if the wall has soft
foundation, use self-tapping screws directly.
Steps
5 / 6
Use tool like scissor to strip
(power) cable, and expose the
metal wires
Twist the positive pole of the power cable with
corresponding metal wire, and use black tape to
cover the metal part
Pre-stripping
Countersunk screw
Slot
Wall
Ground
1.4m
Expansion pipe screw
86-type
cassette
hole
Wall-mount stickers
1.4m calibration tail
Drill here Drill here
Drill here
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
Steps (on the wall):
1. Please follow the calibration tail, and paste
this sticker horizontally on the wall
2. Please follow the marker, and drill the holes
3. Remove the sticker, and install the device
When there is no
86-type cassette,
please drill hole here
as the way out for
power cable and
network cable)
Outlet hole
86-type
cassette
hole
Wall-mount stickers
1.4m calibration tail
Drill here Drill here
Drill here
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
Steps (on the wall):
1. Please follow the calibration tail, and paste
this sticker horizontally on the wall
2. Please follow the marker, and drill the holes
3. Remove the sticker, and install the device
When there is no
86-type cassette,
please drill hole here
as the way out for
power cable and
network cable)
86-type
cassette
hole
Uface C Wall-mount stickers
1.4m calibration tail
Drill here Drill here
Drill here
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
86-type
cassette
hole
Steps (on the wall):
1. Please follow the calibration tail, and paste
this sticker horizontally on the wall
2. Please follow the marker, and drill the holes
3. Remove the sticker, and install the device
When there is no
86-type cassette,
please drill hole here
as the way out for
power cable and
network cable)