Users Manual

Installation notes
1、Cables inside of the touch switch board shall keep far away from the center area of the board back.
2、When arrange the wires, if the 12V power supply cable of the host does not adopt the “Special power
strip” and is in long distance, resulting in large resistance, then abnormal phenomena may occur easily such
as insufficient voltage, repeat restart, system crash and so on.
3、The power adapter with the device is shown as follow, 1m length in total, with 40cm low voltage power
cable and 40cm high voltage power cable.
V
1m
40cm 40cm
(Pictures for reference only, subject to our products)
Power cable (weak current) 12-16V, 2A Power cable (strong current) 220V
Extension of power cable (weak current) can not exceed 2m, otherwise, it may cause insufficient
power supply for the host end, and abnormal phenomena like repeat restart, system crash and so
on may occur. If the power is far away from the device, the power cable can be extended (strong
current).
If use other power adapter, 9V 1A as an example, then insufficient voltage and too weak current
may cause repeat restart.
The cable cannot be too fine (such as network cable and fine line), it is suggested to connect
multi-strand cable in parallel or use copper core bold cable, to ensure voltage >11V.
Attention: If use network cable, the extension cable uses 4-strand cable as positive pole and 4-strand cable as negative pole.
If not clear with how to extend, please contact the provider to change “Special power strip”.
Terminal host
Power
GND
12V
Cable equivalent
resistance1
Cable equivalent
resistance2
Voltage meter
Sensor
DC+
DC-
NO
COM
Wiring connection
7 / 8
Wiring for magnetic door Wiring for automatic door
System installation schematic
drawing for magnetic door
Wiring schematic drawing for touching
switch of magnetic door
System installation schematic
drawing for automatic door
Wiring schematic drawing for mechanical
switch of magnetic door
Wiring schematic drawing
for sensor switch of automatic door
Opening signal PUSH
Public end GND
12V
Controller of auto-door (only used terminals will be listed)
DC+
DC-
NO
COM
Terminal
host
门禁电源
Terminal
host
Auto-door controller
+ assembly units
Sensor (inside)
DC12V Wired or
Wi-Fi
~220V
Door exit
(inside)
Magnetic lock
Power
Terminal host
Wired or
Wi-Fi
~220V
PUSH
GND
12V
COM
NC
NO
12V
GND
NO
NC
COM
﹣12V
﹢12V
Power
Door exit
Magnetic lock
Terminal host
1 3 5 7 9 11 13 15
2 4 6 8 10 12 14 16
12V NO
COM
GND
For detailed definition of the pin, please refer
to the appearance description
For detailed definition of the pin, please refer
to the appearance description
For detailed definition of the pin, please refer
to the appearance description
1 3 5 7 9 11 13 15
2 4 6 8 10 12 14 16
12V NO
COM
GND
NO
NC
COM
Door exit
PUSH
GND
12V
COM
NC
NO
﹣12V
﹢12V
Terminal host
Magnetic lock
1 3 5 7 9 11 13 15
2 4 6 8 10 12 14 16
12V NO
COM
GND
Right
Wrong