User's Manual

5 / 6
1
Paste the installation sticker on the wall, and keep the horizontal line parallel with the ground
and the red line 1.4m distance to the ground; drill screw holes on suitable position on the wall
according to the installation method (if use 86-box, then no need to drill holes), drill 1~2 outlet
holes according to wiring need.
3 Align the interface socket and Ethernet port with device back and insert.
2
the support.
4
Thread the tamper screws into the support and rotate 2 turns, then align the bottom slot with
the support hook, use the hexagonal wrench to tighten screws following the shown direction.
Installation completes.
Steps
Attention: If the wall has hard foundation, self-tapping screws shall be used together with
expansion pipe; if the wall has soft foundation, use self-tapping screws directly.
1.4M
Outlet hole
1.4m calibration line