Operating Instruction

Steps
5 / 6
According to the site requirements, drill a 35mm-diameter hole in the gate (commonly in
the middle or the front), as shown on the picture, is the suggested hole position.
Single-channel gate Dual-channel gate
50CM
Attention: Hole position should be decided by actual scenes and applied gate type, 50cm is the reference value only.
1
2
Put the silicone rear-plug on the position shown on the picture, fix the column and host via
screws, then put the silicone top-plug on specific position.
Silicone rear-plug
Silicone top-plug
4
Insert the column and cables into the hole on the gate, from top to bottom. At the gate
bottom, thread the cable interfaces out the nut one by one, align the nut with thread and
then tighten.
Tighten the nut
3
Attention: a) At this time, do not connect cables such as network cable and power cable, to avoid the trouble of installation.
b) 4 cables cannot be threaded at once from the nut, please thread them one by one, shown as the picture.
Screw off the fixing nut at the column bottom, thread the cables through the nut.
Take down the nut