User's Manual

5 / 6

Paste hole papers, and keep the horizontal line parallel with the ground and the red line 1.4m

distance to the ground. Drill 4 screw holes on the wall according to the reminder of hole paper,

drill 1 outlet hole according to wiring need. If the wall is hard foundation, use expansion pipe in

the parts to knock into the hole.

Move the support (device) to align the 4 holes on it with holes on the wall, and use the

Connect power cable, network cable and other wirings.

4 Fix the device, manually adjust device angle to reach the optimal recognition angle.

Steps

Attention: If the wall has hard foundation, self-tapping screws shall be used together with

expansion pipe; if the wall has soft foundation, use self-tapping screws directly.

1.4M

Outlet hole

wall-mouting sticker

1.4m calibration

Installation steps:

1. Please follow the calibration tail to horeizontally paste

this sticker on the wall

2. Please drill holes according to the mark

3. Remove the sticker, and install the device

Wall