User's Manual

Steps
5 / 6
According to the site requirements, drill a 32mm-diameter hole in the gate (commonly in
the middle or the front), as shown on the picture, is the suggested hole position.
Single-channel gate Dual-channel gate
50CM
Attention: Hole position should be decided by actual scenes and applied gate type, 50cm is the reference value only.
1
2
4
3
Attention: a) At this time, do not connect cables such as network cable and power cable, to avoid the trouble of installation.
b) Please thread the 4 cables out one by one, instead of threading all 4 cables together, as shown on the picture.
Insert the column and cables into the hole on the gate, from top to bottom.
Connect power and network cable, boot the device and display screen. Adjust the support
angle to reach the optimal recognition angle as well as optimal recognition height range.
Take down the nut
Tighten the nut
Inner hexagon screw
Inner hexagon screw
Plastic nut
Use hexagon screw tool or hexagon
screw driver to loosen the screw,
adjust the angle and then tighten