Users Manual

Steps

5 / 6

Wiring instruction

Use tool like scissor to strip

(power) cable, and expose the

metal wires

Twist the positive pole of the power cable with

corresponding metal wire, and use black tape to

cover the metal part

Paste hole paper on the wall, keep the horizontal line parallel with the ground and the red line

1.25m distance to the ground. Drill 4 screw holes on the wall according to the reminder of

hole paper, drill 1 outlet hole according to wiring needs, please use expansion pipe in the

parts to knock into the hole if for wall with hard foundation.

Expansion

pipe screw

Outlet hole

1.25m

Ground

Fix the device, adjust the device angle manually to reach the optimal recognition angle.

Please follow the calibration tail,

and paste this sticker horizontally on the wall

1.35m calibration tail

Steps (on the wall):

1. Please follow the calibration tail, and paste this

sticker horizontally on the wall

2. Please follow the marker, and drill the holes

3. Remove the sticker, and install the device

Drill here

Move the support (device) to align the 4 holes on it with holes on the wall, and use the screws

to ﬁx the support (device) on the wall.

Attention: If the wall has hard foundation, self-tapping screws shall be used together with expansion pipe; if the

wall has soft foundation, use self-tapping screws directly.

Wall

Take oﬀ the protection circle

on the pre-stripping wire of

socket cable

Pre-stripping