Operator`s manual

SETUP AND OPERATION CONTINUED

1. With power OFF, select the container to be labeled, place on conveyor

for reference and adjust vertical height of guide rails. This is

accomplished by loosening the ratchet handles at each guide rail

mount. After adjusted, re-tighten ratchet handles. (See Fig.5)

Put two containers on conveyor in front of the Turning Unit. (See Fig.6)

Adjust the cross adjust of the guide rail by loosening the knob at the top or

side of each guide rail mount. (See Fig.5) Slide Backing Plate up to

containers until snug. After adjusted, re-tighten knob. (See Fig.7) Adjust

the entrance and exit guide rails in the same manner, but to be a loose fit.

FIG.5

Guide Rail

mount

Ratchet

Handle

Fig.6

Knob

Fig.7

Turning

Unit

Backing

Plate

Turning Unit Belt

Backing Plate

Snug