Operator`s manual

16
WEBBING THE L-15
1st. Turn the Applier switch on the control enclosure off.
2nd. Do not use a label to attach the web to the rewind spool; this will make
the
removal of the waste roll difficult.
Web the machine by looking at the webbing diagram located on the side of the
L-15 body.
1. Mount the label roll to the unwind hub. Push label roll straight back against
the unwind backing plate. Slide the label roll retainer onto the unwind hub
until it contacts the label roll. Tighten thumb screw.
2. Remove approximately 30 inches of labels from label roll backing web.
3. Route the web over brake idler roll and between the idler roll and web
drag then down through the Sensor. (See Fig.14)
Fig.14
Unwind Hub
Unwind Backing
Plate
Label Roll Retainer
Thumb
Screw
Brake Idler
Roll
Sensor
Web Drag
Idler Roll