Operator`s manual

ADJUSTING THE PEELER ASSEMBLY

Now that the Conveyor and Turning Unit are speed matched, Adjust Peeler

Plate so it is close but not touching the Turning Unit. The Peeler Assembly

can be adjusted by loosening the Height Adjust Bracket and loosening the

Peeler Plate Pivot Blocks. (See Fig.18, 18a & 18b)

SETTING THE SPEED OF THE L-15

1. Turn the Applier switch to ON.

2. Run one container down the conveyor. Watch when the label is applied. If

the Turning Unit pulls the label from the peeler plate, the L-15 is going too

slow. (See Fig.19) If the L-15 is pushing the label onto the container, the

L-15 is going to fast. (See Fig.19a)

3. If the web is being pulled, adjust the speed control of the L-15 up. If the

label is being pushed, adjust the speed control of the L-15 down. Once

these adjustments are made you should have a smooth label transfer.

Turning Unit

Peeler Plate

Pulling Web Pushing Label

Turning Unit

Peeler Plate

Fig.19 Fig.19a

Fig.18

Fig.18a Fig.18b

Peeler Plate

Height Adjust Bracket

Pivot Blocks