Operator`s manual

TROUBLESHOOTING CONTINUED

LABEL DISPENSING FROM APPLICATOR CONSTANTLY

Make sure that the label web going threw the label sensor. Make sure that the

label sensor is plugged into the applicator. Check the label sensor to see if it is

working. Make sure that product sensor is not seeing the trailing edge of the label

as it goes by. Try re-setting label sensor. (See Fig.16)

WASTE WEB NOT WINDING ON REWIND

Adjust rewind take-up. To adjust the rewind take-up, there is a jam nut on the

opposite side of the rewind assembly. Loosen the jam nut. By turning the

adjuster clock wise, it will increase the tension of the rewind.

SECTION 5 MAINTENANCE

SYSTEM MAINTENANCE

1. Lubricate bearings that are on the conveyor.

2. Keep conveyor mat top chain clean.

3. Check all motor brushes.

4. Clean turning unit belt.

5. Keep peeler tape on end of peeler plate clean and nick free or replace.

6. Check that nuts and bolts are tight.

7. Keep fiber optics of the product sensor clean.