Operator`s manual

ROUNDER DISASSEMBLY AND CLEANING:
1. Shut off both the divider and the rounder and disconnect the power supply cord.
2. Unscrew the two rounder guard knobs and remove the rounder guard.
3. Pull the rounder out from under the divider far enough to remove the rounder bell.
4. Unscrew the rounder bell knobs and remove the rounder bell.
5. The rounder bell may be placed in a sink for cleaning.
6. Clean the rounder bell with water and mild detergent.
7. Clean the rounder bowl, chute and guard with a wet cloth.
8. Spray a commercial non-toxic sanitizer on the rounder bowl and bell as recommended on the
sanitizer container label. It is important that the sanitizer be compatible with anodized aluminum.
9. Reassemble the rounder in the reverse order of the above disassembly.
10. Always run the divider and rounder without dough after each cleaning.
ROUNDER
FIGURE 8
Guard Knobs
Rounder Guard
Rounder
Guard Knobs
Bell Knobs
Rounder Bell
Chute
Rounder Bowl
Page 9