Manual

Table Of Contents
“ROTANTE” pizza oven
R-002 100218
Page 4 of 43
1. GENERAL NOTICE
1.1 Test and warranty
The oven and its components have already been tested at our plant in compliance with the
applicable regulations and laws, and are delivered ready for use.
Any attempt to disassemble, change or, in general, tamper with any part of the equipment
will invalidate the
warranty.
Any improper use of the oven, as well as any attempt to disassemble and modify the oven,
can lead to accidents and therefore Univex declines any responsibility for potential injuries
or damages resulting from tampering. In case of anomalies, please consult your
local authorized customer service center and, more specifically, contact directly the
manufacturer for help with assembling, installing or moving the equipment. The
manufacturer shall be relieved from any responsibility in the following cases:
Improper use of the equipment by inadequately trained personnel.
Installations that are not compliant with applicable laws in the country of use and
performed by non-authorized personnel.
Scheduled routine maintenance that was not carried out or that was performed
incorrectly.
Use of non-original or non-approved replacement parts.
Partial or total non-observance of the instructions.
The warranty is effective as per 12 months since the delivery date and covers the
replacement or repair of any faulty part, except for electric or electronic components and
parts. The manufacturer should be notified of any visible defect or anomaly within 5 days
since the date of receipt to be able to conduct an inspection.
Any other defect that might be seen upon receipt of the oven should be notified within 5
days since it was noticed and in any case within maximum 6 months.
The buyer has the right to request the repair or replacement of the faulty parts only, since
the warranty does not cover in any way the damages related to any other direct or indirect
cause.
The repair and replacement of faulty parts should be requested within the maximum limit
as outlined in the warranty unless otherwise specified by law.
Damaged or faulty parts will be repaired or replaced by the manufacturer. The buyer is
therefore responsible for sending free of carriage charges the above-mentioned parts to
the manufacturer, who will resend them to the buyer.
1.2 Client's responsibilities
The client should be held responsible for the following: