Manual
Table Of Contents
 “ROTANTE” pizza oven
R-002 100218
Page 4 of 43 
1. GENERAL NOTICE
1.1  Test and warranty 
The oven and its components have already been tested at our plant in compliance with the 
applicable regulations and laws, and are delivered ready for use. 
Any attempt to disassemble, change or, in general, tamper with any part of the equipment 
will invalidate the  
warranty. 
Any improper use of the oven, as well as any attempt to disassemble and modify the oven, 
can lead to accidents and therefore Univex declines any responsibility for potential injuries 
or damages resulting from tampering. In case of anomalies, please consult your 
local authorized customer service center and, more specifically, contact directly the 
manufacturer for help with assembling, installing or moving the equipment. The 
manufacturer shall be relieved from any responsibility in the following cases: 
 Improper use of the equipment by inadequately trained personnel.
 Installations  that  are  not  compliant  with  applicable  laws  in  the  country  of  use  and
performed by non-authorized personnel.
 Scheduled  routine  maintenance  that  was  not  carried  out  or  that  was  performed
incorrectly.
 Use of non-original or non-approved replacement parts.
 Partial or total non-observance of the instructions.
The  warranty  is  effective  as  per  12  months  since  the  delivery  date  and  covers  the 
replacement or repair of any faulty part, except for electric or electronic components and 
parts. The manufacturer should be notified of any visible defect or anomaly within 5 days 
since the date of receipt to be able to conduct an inspection. 
Any other defect that might be seen upon receipt of the oven should be notified within 5 
days since it was noticed and in any case within maximum 6 months. 
The buyer has the right to request the repair or replacement of the faulty parts only, since 
the warranty does not cover in any way the damages related to any other direct or indirect 
cause. 
The repair and replacement of faulty parts should be requested within the maximum limit 
as outlined in the warranty unless otherwise specified by law. 
Damaged or faulty parts will be  repaired or replaced by the manufacturer. The buyer is 
therefore responsible for sending free of carriage charges the above-mentioned parts to 
the manufacturer, who will resend them to the buyer. 
1.2  Client's responsibilities 
The client should be held responsible for the following: 










