Instruction manual

Page 2

MG8912

Insert the housing of the Grinder Head Assembly into the PTO housing of the Drive

Assembly. Tighten the thumb screw and assure that the engagement is

proper and secure. Lightly

coat the Drive Shaft (Item 9) and Fiber Washer (Item 10) of the Worm Assembly with

Drive Shaft

Lubricant (Item 16). Insert the Worm Assembly into the Housing, assuring that it

is engaged in the

PTO adapter.

The Knife and Grinder Plate (Items 13 & 14) should be coated with the lubricant

provided

or beef tallow prior to assembly. Place the Knife, SHARP EDGES OUT, on the

square extension

of the Worm Assembly. Place the Grinder Plate on the

worm assembly extension so that the notch

in the plate engages the pin in the grinder housing. Screw the Hand wheel Ring

(Item 15) on the

housing assembly using only minimum force. The ring controls the

pressure between the plate and

the knife. The knife is easily damaged by dry running

or excessive force on the Hand wheel Ring.

Mount the Feed Pan on the top of the Drive Assembly so that its outlet

spout engages the

inlet throat of the Grinder Assembly Housing.

PROCESSING

Locate the equipment for the convenience of the operator, allowing free

access to the power

switch and sufficient clearance for safety and care of operation. Slice the

meat into strips which

will easily fit into the outlet of the Feed Pan. Place a suitable container

at the discharge of the

Grinder Head. Place the meat in the Feed Pan and start grinder. Hand feed the

meat into the outlet

of the pan using the stomper to feed the meat into the grinding

worm. Do not use the stomper to

force feed the grinder at an increased rate. Best results

are obtained when the meat is fed only as

fast as the grinder processes it. Switch the power 'OFF when processing is interrupted.

When the

processing has been compled, switch the power "OFF" and disconnect the

power supply cord.

Dismount the Grinder Head from the Drive. Disassemble, wash, and dry the

components of the

Grinder Head. Store the components in a refrigerator for added sanitation.

PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor