- Netgear Smart Wireless Switch Hardware Installation Guide

WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide
2-8 Installing the Chassis
v1.0, May 2007
For more information on LED behavior, see “System Indicator LEDs” on page 1-2.
2. Check the fans to verify they are working.
You should be able to hear the fans operating and feel significant airflow blowing from the
chassis vents at each of the three fan positions.
3. Connect appropriate network cables (see Appendix A, “Cables and Connector Pinouts” for
port and cable information).
4. Perform the initial setup as described in Installation Guide: WFS709TP ProSafe Smart
Wireless Switch.
Warning: If one or more fans do not work, immediately shut down and contact
NETGEAR.