Manual

ROTORBAKE Series Ovens - electric version - Page 33

BAKING

Turn the main switch G, and turn on the oven’s computerized control by pressing the on -

off key:

Select the baking program for the product to be baked by pressing the program key N; the

relative number will start to flash on the Program display L, modify this number using the

(+) key O, and the (-) key M, then confirm the setting by pressing the Enter key P.

Press the Start key S, to begin an automatic phase, which will bring the oven to the

preheating temperature, 50 degrees higher than the temperature set in the baking program.

On completion of this phase, a buzzer will inform the operator that the oven is ready to start

baking.

When the door is opened the oven will switch off, allowing the operator to place the product

inside.

Once the product is in the oven, the operator has only to check that the door is properly

closed; the oven will continue automatically until baking is complete.

To vary the programmed temperature temporarily during the baking, simply press the

Temperature key R, modify using the (+) key O, and the (-) key M, then confirm by

pressing the Enter key P.

Note that the variation made in this way will only be active for the baking cycle in progress

and will not be memorized in the baking program selected.

Warning!

At the end of the baking time the oven does not stop its functions

AUTOMATICALLY!

At the end of the baking time, the oven will sound a beeper until you give the baking end

command by pressing the Stop key U, or by simply opening the oven door.

Baking in accordance with the program you selected previously is now complete, but a new

temporary “baking time” can be set to further prolong baking.

If this is required, press the Time key T, and the relative display H, obviously showing zero,

start to flash; modify the baking time using the (+) key O, and the (-) key M, then confirm

by pressing the Enter key P.

This function is only available within 60 second after the end of the programmed baking

and is indicated by flashing of the led on the Stop key U.

 

  